2, adjust the center distance of the feed, feeding - printing plate - die cutting board should be in a straight line.
3. Adjust the feed roller gap and the printing roller gap. The feed roll gap was tested by using the same thickness of the product, and the print roll gap was tested by using a thickness of the article + a printed board of the same thickness.
4. Adjust the ink and turn on the ink. If the ink is too dark, it can be diluted with water.
5. Adjust the feed speed and the starting position of the printing roller.
6, boot, first try with a plate, adjust the roll pressure according to the test results (if the color is too light, reduce the gap of the roller), and adjust the position of each group of colors (contrast drawings, find a point comparison, measure distance And adjust the roller of the corresponding color). Pay attention to the direction of the roller when adjusting the position, do not transfer it.
7. After the printing group is adjusted, it is linked with the die-cut group. Take the material into the die-cut test, according to the test results, compare the design drawings, adjust the position and clearance
8. After the printing and die-cutting are adjusted, the conveyor and automatic stacking can be put down and the production can begin.
9, the normal production speed of this machine is about 80 / min.
10. If you only need to stop for 1-2 hours, you don't need to clean it, but keep the inking system open and cycle to avoid the ink from drying out. If you want to stop for a long time, you must clear the ink of the pipe and the ink of the template. Every time you clean the ink, you will waste about 500 plates of ink. It is recommended that the customer run it for a long time after starting up to avoid wasting ink.
1,We have all series plastic hollow corrugated sheet making machine in production,warmly welcome to visit our factory for machine running.The machine running is the best prove of the machines' quality ,the good quality machine is the granulating for the high effective production.
2,We can testing the machine according customer's formula.One is the customer can inspect the quality of our machine,another is the customer can check the quality of the products,so it is easy to calculate the cost of the sheet and the production capacity of our machines.So it's easy to calculate the investment pay back and increase the feasibility of the project.
3,We are professional for the auxiliary machine for sheet raw material making and plastic boxes making.We can provide the plastic filler masterbatch granulating making machine,the wast sheet crusher,the raw material mixing machine,the die cutting machine,the corona treatment machine,the sheet printing machine,the welding / bookbind machine .
4,Our engineer oversee installation and debugging ,our engineer with rich experience and will teach customer's worker about the operating one by one.And we provide long life time technical support.
- Centralized feeding system for PP hollow corrugated sheet machineThe centralized feeding system can automatically weigh and accurately mix raw materials, saving manpower and improving production efficiency.We can offer the turnkey project for the plastic hollow sheet corrugated box making machine.2019-12-11
- 2100mm PP hollow sheet machine loading to Dominija5 sets 40 feet container for pp hollow corrugated sheet box making machine, 1,raw material mixer 2,Sheet extruder machine 3,corona treatment machine 4,automatic printing and die cutting machine2019-12-06